U1122 Code: Meaning, Symptoms, Causes & Fix

U1122

Overview

When U1122 appears, the control module has detected abnormal behavior related to SCP (J1850) Invalid or Missing Data for Odometer in module-to-module CAN communication.

Symptoms

  • multiple warning lights at once
  • feature communication timeout
  • module not responding in scan tool

Common causes

  • Component failure in the monitored system affecting scp (j1850) invalid or missing data for odometer
  • Control module logic or calibration issue
  • Connector pin damage/corrosion or harness stress near related components

How to diagnose U1122

  1. Confirm U1122 and capture freeze-frame data with a professional scan tool.
  2. Inspect wiring, connectors, and grounds related to scp (j1850) invalid or missing data for odometer for obvious defects.
  3. Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
  4. Check for related DTCs to identify the root-cause chain before replacing parts.
  5. After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U1122

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U1122?

Most vehicles can be driven short-term with U1122, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

  1. Repair obvious wiring/connector faults first to prevent repeat parts replacement.
  2. Address the root fault mode (generic) in the scp (j1850) invalid or missing data for odometer circuit/system.
  3. Apply the required relearn/adaptation procedure if specified by service information.
  4. Road-test and verify U1122 remains cleared under the conditions that originally set the code.

Fix options

  • Inspect circuit and connector condition.
  • Test component operation and replace if faulty.
  • Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U1122

  • Replacing parts without verifying voltage, ground, and signal integrity first.
  • Ignoring related stored/pending codes that indicate upstream faults.
  • Skipping post-repair verification drive cycle and readiness checks.

U1122 in common vehicles

U1122 appears across makes such as Mazda, Subaru, Lexus, Jeep. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U1122?

U1122 is commonly set by generic faults affecting scp (j1850) invalid or missing data for odometer.

How much does it cost to fix U1122?

For U1122, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U1122 without repair?

You can clear U1122 temporarily, but the code usually returns until the underlying fault is corrected.

Helpful tools