U1137 Code: Meaning, Symptoms, Causes & Fix

Overview

Code U1137 indicates a fault in SCP (J1850) Invalid or Missing Data for Telltales, typically within module-to-module CAN communication.

Symptoms

intermittent no-start or limp mode
module not responding in scan tool
feature communication timeout

Common causes

Control module logic or calibration issue affecting scp (j1850) invalid or missing data for telltales
Component failure in the monitored system
Connector pin damage/corrosion or harness stress near related components

How to diagnose U1137

Confirm U1137 and capture freeze-frame data with a professional scan tool.
Inspect wiring, connectors, and grounds related to scp (j1850) invalid or missing data for telltales for obvious defects.
Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
Check for related DTCs to identify the root-cause chain before replacing parts.
After repair, clear codes and confirm readiness monitors complete without recurrence.

Severity of code U1137

Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.

Can you drive with U1137?

Most vehicles can be driven short-term with U1137, but postpone heavy load/highway driving until repaired.

If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.

How to fix it (step-by-step)

Repair obvious wiring/connector faults first to prevent repeat parts replacement.
Address the root fault mode (generic) in the scp (j1850) invalid or missing data for telltales circuit/system.
Apply the required relearn/adaptation procedure if specified by service information.
Road-test and verify U1137 remains cleared under the conditions that originally set the code.

Fix options

Test component operation and replace if faulty.
Clear code and confirm through drive cycle.
Clear DTCs and verify with live data and completed drive cycle.

Typical repair cost

$260-$1300

Common mistakes when diagnosing U1137

Replacing parts without verifying voltage, ground, and signal integrity first.
Ignoring related stored/pending codes that indicate upstream faults.
Skipping post-repair verification drive cycle and readiness checks.

U1137 in common vehicles

U1137 appears across makes such as BMW, Mercedes-Benz, Audi, Volvo. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.

Frequently asked questions

What causes U1137?

U1137 is commonly set by generic faults affecting scp (j1850) invalid or missing data for telltales.

How much does it cost to fix U1137?

For U1137, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.

Can I clear U1137 without repair?

You can clear U1137 temporarily, but the code usually returns until the underlying fault is corrected.