When U1163 appears, the control module has detected abnormal behavior related to SCP (J1850) Invalid or Missing Data for Digital Audio Tape in body electronics and comfort modules.
U1163 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- module resets or glitches
- feature inoperative intermittently
- battery draw complaints
Common causes
- Electrical fault in the affected circuit affecting scp (j1850) invalid or missing data for digital audio tape
- Component failure in the monitored system
- Connector pin damage/corrosion or harness stress near related components
How to diagnose U1163
- Confirm U1163 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to scp (j1850) invalid or missing data for digital audio tape for obvious defects.
- Use freeze-frame and live data to isolate whether the issue is electrical, mechanical, or control logic.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code U1163
Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.
Can you drive with U1163?
Most vehicles can be driven short-term with U1163, but postpone heavy load/highway driving until repaired.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (generic) in the scp (j1850) invalid or missing data for digital audio tape circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify U1163 remains cleared under the conditions that originally set the code.
Fix options
- Clear code and confirm through drive cycle.
- Inspect circuit and connector condition.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$160-$850
Common mistakes when diagnosing U1163
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
U1163 in common vehicles
U1163 appears across makes such as Nissan, Hyundai, Kia, Volkswagen. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes U1163?
U1163 is commonly set by generic faults affecting scp (j1850) invalid or missing data for digital audio tape.
How much does it cost to fix U1163?
For U1163, repair costs are typically $160-$850 depending on exact root cause, labor rates, and part quality.
Can I clear U1163 without repair?
You can clear U1163 temporarily, but the code usually returns until the underlying fault is corrected.