When U2013 appears, the control module has detected abnormal behavior related to Compass Module is not Responding in module-to-module CAN communication.
U2013 Code: Meaning, Symptoms, Causes & Fix
Overview
Symptoms
- intermittent no-start or limp mode
- module not responding in scan tool
- feature communication timeout
Common causes
- CAN communication path fault affecting compass module is not responding
- Target module offline
- Connector pin damage/corrosion or harness stress near related components
How to diagnose U2013
- Confirm U2013 and capture freeze-frame data with a professional scan tool.
- Inspect wiring, connectors, and grounds related to compass module is not responding for obvious defects.
- Confirm module power/ground first, then validate network traffic to the target module.
- Check for related DTCs to identify the root-cause chain before replacing parts.
- After repair, clear codes and confirm readiness monitors complete without recurrence.
Severity of code U2013
Moderate: This code is moderate severity: the vehicle may still operate, but fault progression can increase repair cost over time.
Can you drive with U2013?
Most vehicles can be driven short-term with U2013, but postpone heavy load/highway driving until repaired.
If the warning lamp is flashing or drivability/safety is affected, avoid driving and diagnose immediately.
How to fix it (step-by-step)
- Repair obvious wiring/connector faults first to prevent repeat parts replacement.
- Address the root fault mode (not responding) in the compass module is not responding circuit/system.
- Apply the required relearn/adaptation procedure if specified by service information.
- Road-test and verify U2013 remains cleared under the conditions that originally set the code.
Fix options
- Reflash or replace non-responding module if needed.
- Check module wake-up power and grounds.
- Clear DTCs and verify with live data and completed drive cycle.
Typical repair cost
$260-$1300
Common mistakes when diagnosing U2013
- Replacing parts without verifying voltage, ground, and signal integrity first.
- Ignoring related stored/pending codes that indicate upstream faults.
- Skipping post-repair verification drive cycle and readiness checks.
U2013 in common vehicles
U2013 appears across makes such as Ford, Toyota, Honda, Chevrolet. Failure patterns differ by platform: wiring routes, software calibration, and component supplier revisions can change root cause.
Frequently asked questions
What causes U2013?
U2013 is commonly set by not responding faults affecting compass module is not responding.
How much does it cost to fix U2013?
For U2013, repair costs are typically $260-$1300 depending on exact root cause, labor rates, and part quality.
Can I clear U2013 without repair?
You can clear U2013 temporarily, but the code usually returns until the underlying fault is corrected.